These Swarovski crystal and pearl bead earrings are so delicate and beautiful! They are easy to make and fun to wear. They would also make for a great gift to give on any special occasion.

What you’ll need:

  • 8mm Round Ivory Swarovski Pearl SW00726 (4)
  • 4mm Bicone Crystals, Light Amethyst SW00195 (6)
  • 6mm Bicone Crystals, Light Amethyst SW00196 (2)
  • 11/0 Lilac Lined Semi-Matte Seed Bead SB00435
  • 3mm Gold Round Beads Z001310
  • Gold Plated Hoop A013205
  • Ear wires TCZ0148
  • Gold Headpin A019651

Note: Directions are for making wrapped loops. If you prefer to make simple loops, we suggest using a harder gauge wire like A019658.

 

DIY Swarovski® Amethyst & Pearl Hoop Earrings

 

Directions:

  1. Slide on a headpin; 4mm bicone and seed bead. Make a simple or wrapped loop. Make a total of 4 dangles.
  2. Slide on a headpin; seed bead, 3mm round bead, pearl and seed bead. Make a simple or wrapped loop. Make a total of 4 dangles.
  3. Slide on a headpin; seed bead, 3mm round bead, 6mm bicone, 3mm round, seed bead, 3mm round, 4mm bicone and seed bead. Make a simple or wrapped loop. Make a total of 2 dangles.
  4. Cut the tab part of a hoop finding off.
  5. Make a simple loop to one end of your hoop perpendicular to the loop of the hoop.
  6. Slide on the following to the hoop: 3mm round, step 1 dangle, 3mm round, step 2 dangle, 3mm round, step 3 dangle, 3mm round, step 2 dangle, 3mm round, step 1 dangle and 3mm round.
  7. Slide other hoop end through loop you make in step 5 and roll back a simple loop.
  8. Open ear wire loop and slide on hoop dangle. Close loop.
  9. Repeat Steps 4-8 for other earring.

Shop All Earring Kits